Description

Brand Adlite Packaging Size 25 Kg Packaging Type PP Bag Coverage Area 50 - 60 sq.ft/ 25 kg bag @ 3 - 4mm thickness Form Powder Bed Thickness 3 - 4 mm Pot Life Approx 45 minutes Mix Proportion 20 - 25% by weight Time Of Traffic Grout after 12 hours; light foot traffic after 24 hours; Full traffic after 48 hours(depending on si Open Time 20 - 30 minutes Shelf Life 6 Months Tensile Adhesion Strength >1N/mm2 after 28 days Floor Tile Adhesive is a cementitious ready powder which is thin-bed and a polymer modiied product. Its unique properties make it ideal for mixing ceramic tiles, vitrified tiles, mosaic tiles and other flo or tiles. Special Properties Of “Adlite Tile Adhesive - Floor” : Preparation is simple, just add water. Although cement based, requires no curing. High tensile adhesion strength. Grouting is possible on the same day. Polymer modified formulation enhances its durability. Being ready to use, the product saves considerable time and labour. Areas Of Use: To fix floor tiles like ceramic, vitrified, mosaic and other floor tiles. Cementitious screeds. Bathrooms, kitchens etc. Concrete Floors And Walls : Allow 3 - 4 weeks for concrete to cure, prior to tiling. Screeds must be 5-7 days old and properly cured. The surface should be properly levelled for best results of “Adlite Tile Adhesive - Floor”. Remove curing compounds, if any, from the surface. Fibre Cement Sheets: Fibre cement sheets must be primed with water and all joints must be taped with PVC duct tape and fixed according to the manufacturer’s instructions. Preparation Of “Adlite Tile Adhesive - Floor”: Take a small amount of water in a bucket and gradually add “Adlite Tile Adhesive - Floor” in it. Mix the product with water in the ratio of approximately 1:4. Mixing can be done manually or by stirrer. Mixing to be done till homogenous lump free mix is obtained. After proper mixing, leave the paste for 5-10 minutes for polymeric dispersion before application. The paste should be kept away from direct sunlight, heat and used within 45 minutes of preparation (after mixing with water). Surface Preparation : The surface should be clean, dry, and free from dust, grease / oil and other contaminates. Do’s About “Adlite Tile Adhesive - Floor”: Before fixing the tiles, clean the backsides of these with wet cloth to remove all dust particles. Apply a layer of adhesive on the substrate and spread it by notch trowel. Lay the tiles and press firmly. Then knock properly with rubber hammer in order to spread the adhesive equally and for a good contact. Remove any surplus adhesive on the face of the tiles. Any adjustment should be done within 20 - 30 minutes before adhesive starts hardening. Wait for at least 12 hours before grouting for better contact. Useful Tips : The surface should be clean, dry, and free from dust, grease / oil and other contaminates. “Adlite Tile Adhesive - Floor” should be stored in a dry place. It is recommended that when fixing tiles, a minimum spacing of 3mm should be left around each tile. Excess adhesive should be removed using a damp sponge or cloth before material has set. Floors will be ready to receive light foot traffic after 24 hours and can be put into full use after 72 hours. Don’ts About “Adlite Tile Adhesive - Floor”: Avoid very high speed mixing when electric mixing equipments are used. Although “Adlite Tile Adhesive - Floor” Is Nonhazardous,Following Precautions Should Be Adhered: Keep out of reach of the children. Avoid inhalation of dust. In case of contact with eyes, rinse eyes with plenty of water and consult a doctor immediately.